(FIXED) Identity Disk - V2
As with the previous design, is intended to use two soldered 9 volt-powered 335 LED strips (one 20 inches long and one 24 inches long from http://glowhut.com/) that go to the same 9-volt battery.
Two versions are included in the files, a full version for larger printers and a half version for smaller ones. You will need to print 12 Spokes models in total, and each side of the disk are different designs (one side with magnet holes and another with none), meaning the disks on either side are NOT interchangeable with each other.
ā
šš» š¼šæš±š²šæ šš¼ šŗš®šøš² š® š³šš¹š¹ š±š¶ššø, ššµš² š³š¼š¹š¹š¼šš¶š»š“ š½š®šæšš š®š»š± š»ššŗšÆš²šæ š¼š³ ššµš²šŗ š®šæš² šæš²š¾šš¶šæš²š±:
1 x 'Disk_Face_1_No_Magnets'
1 x 'Disk_Face_2_Magnets'
1 x 'Internal_Ring'
1 x 'Light_Mount'
2 x 'Light_Insert'
(optional A) 1 x 'Blade_-_Off'
(optional B) 1 x 'Blade_-_ON'
12 x 'Spoke'
ā
This is a redesigned and more complex version of https://www.thingiverse.com/thing:7147903. It is a big work in progress and any makes with documentation would be greatly appreciated! Features interchangeable blades and LED circuit; rings the lights are attached to can be swapped out and replaced with another identical ring with different colored lights attached, and the blade can be removed and replaced with a version that appears 'off'. Great for quick adjustments for cosplay situations or for just general decor with a specific color/configuration (I'm considering making a stand for it).
Instructions are included in images 3-5 on the images section. Has quite a few new parts to simplify printing and retain dimensions (limited overhangs) as well as the interchangeable elements of the disk, and will require a combination of superglue/epoxy and magnets (https://www.harborfreight.com/10-piece-rare-earth-magnets-67488.html) to assemble. Uses the same switches as before, even if I haven't tried it myself successfully yet (https://www.amazon.com/dp/B07V1TRMMC?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1).
šš/š®/š®š± - Modifications made to Light and Internal Rings to reduce printing material and to fully enclose sections they need to support.
šš®/š“/š®š± - Fixed a SEVERE problem where Spoke, Blade ON, and Light Mount were corrupted during publishing, leaving them corrupted and without geometry.