Lego-like Batarang - Split

Took the prior batarang and split it to print vertically, so it needs almost no support. There are also pin cut outs to use the same pins as for similar figures.

Note on Supports

I do still generate supports for this, because of the overhang on the wings. I also use support blockers on the inside of the pin holes, as most printers should easily handle the bridging and the generated support would be difficult to remove.

Note on Scale

I typically print these figures at about 5X of a standard minifig, where the original model linked above is for 10X. So be cautious of the scale when printing. A basic sanity check that it fits your expected figure size may save a wasted print.