Fiber Optic Sight for Crosman 1322 Silencer Remix

This is a remix of the clip on sight only of the 1322 Silencer Remix from andyFun (Thank you!) who remixed it from the original 1377 version by dasaki.

I tried to add a white or colored front sight but they were just not working against the white paper targets in my garage range.

Using 1.5mm fiber optic rod (https://a.co/d/abpw5gO), I modified the front sight in Tinkercad to allow a 9.29mm length to provide a better dot.

Once printed, you may need to slightly bore out the hole. I used a 1/16" drill bit on both openings at a slightly upward angle from outside to inside to ensure that the fiber optic rod stayed secured. Once bored, slide the fiber optic rod in from the rear to the front of the sight then snip with cutters like filament flush against the sight. To secure the rod further, a small drop of super glue at each end could be used; however I did not.