Rogue One Jedha Thermal Detonator

This model was created in 3D Builder using measurements taken from screenshots. The slots in R1 TD Body 1 allow for LEDs to show, should you install electronics. The exploded view (pun intended) shows assembly. Glue and/or very small screws (M2) can be used. You can print this in your choice of material. If you orient them correctly, there should be little need for supports. The film, very briefly, shows a T-handle "pin" being pulled as it is deployed. I have not created this yet, but I will add it soon.
Update: I ran a test print (BambuLab P1S 0.4 nozzle, 0.16 layer, SunLu PLA. There were some fitting issues, so I re-sized a few of the parts and remodeled the top cap.
Update: Added the activation pin