HPLC ALS vial tray for HP/Agilent 1100 series

This is a custom 40-position vial tray I created for the HP/Agilent 1100 HPLC system. I had to cut corners (pun intended!) to make it fit withing a standard 200x200 print bed.
compatible with PN: G1313-44502; G1313-44512; G1313-44612

Printed using a 0.4mm nozzle at 0.2mm layer height. Suggested settings are 10% infill, 2-layer outer wall, minimum of 6-layer floor and ceiling and 20% zig-zag support.
I printed mine at 200C for the hot-end and 70C for the bed (a tad high, I know, but I have an old glass bed and would otherwise have adhesion issues).

Please note that small pieces of black and white tape (or matte paint) must be placed on the end bit as shown in picture to allow for correct tray detection.
Seems to fit and align well on my system, but please verify arm alignment before running a full sequence! I take no responsibility for lost samples/stuck arms/bent needles etc...