Blades for ThinkPad fan

Fan, or fan blades to be more specific, broke on my ThinkPad P16 gen 2 and I, being a cheapskate, was looking for a cheapest solution possible and came up with this.
The blades are 0,2mm thick but I printed with 0,4mm nozzle and I was more than happy with the results.
Just break off remaining blades, if any, and squeeze this part over the rotor.
Make sure it is spinning freely and maybe add a dash of glue just to be on the save side.
Sorry, I forgot to take pictures and I sure as hell will not be disassembling my laptop just to take some :)

Important!
If you will print this using PLA, as I did, make sure you anneal the part or you risk it bending due to heat.
I have PLA parts under the hood of my car, where 90 degrees Celsius (194 freedom units) is a normal thing and none of the parts bent the slightest.