Table Saw Fine Blade Adjustment Gauge (Up to 3 inches)

I didn't really need this, but at the same time I did, and so do you.

• Right side is stepped every 1/4 inch
• Left side is stepped every 1/8 inch, but marked every 1/4 inch (and the markings are opposite the markings on the Right side so you get the full stack)
• No supports needed
• Print flat
• Print .2mm layer height and change the filament at about layer 117 to get different color markings with only 1 filament change
• Prints in 2-3 hours
• Looks good
• Feels good in the hand
• Can't comb your hair with it, effectively anyway.