Insulin Injection Supply Storage Box

This is a variant of my Origami Storage Box for storage of Insulin Injection Pens, Alcohol Wipes and Needles.
Magnetic latches have been added.

Print QTY
2X Top Outside Corner
2X Top Inside Corner
2X Top Center
2X Bushing (Pick Flat Head or Button Head as needed)
1X Knob
1X Latch Plate
1X Box Base
1X Door

Hardware
2x M5x16 Button Head
2x M5 Nuts (Nyloc is Optional)
1x M4x12 Flat Head (MUST BE Magnetic, Block Oxide Etc.)
4x M3x16 Flat or Button Head
2x M3 Nuts
3x 6x3 Round Magnets
Some Filament for the hinges of the top cover
4x Rubber feet Optional

Printing notes
Door: Print in the orientation it loads in, On Edge and use supports.
Knob: You will need to pause and insert the M3 Nuts in this print. Pause at ~11.4mm
Base: May need supports Base on your bridging capability for the Rubber Feet pockets.
Other Part should be self-explanatory and should not need supports.

Assembly
TOP: The corners are attached to the center with a length of filament.
Magnets: Glue in Place. 1 in the Latch Plate. 1 in the Door and 1 in the Base. The magnets in the Latch Plate and Door should be orientated to attract.
Door: M4 Screw goes on the right side. Should be flush with surface.
Door to Base: There are 2 6mm holes on the front edge of the base. The Bushings go in these holes and an M3 screw attaches them to the Door.
Top to Base: Top Outside Corner is attached to the Base in the rear corners with the M5 Screws. The M5 Nuts insert in the pockets inside the base.
Knob to Top: Orient Top into the Open Position. Use the M3 screws to attach the Latch Plate and Knob to the Inside corners of the Top. The Latch Plate should have the magnet orientated to the front to the box.

Update:
4/28/26 Made the Pen slots longer (165mm to 170mm) to fit more pens.