RC Jet Boat

My own take of an RC jet boat.
Heavily remixed the hull of: https://www.thingiverse.com/thing:930577
And AI-generated impeller, which turned out to be almost 2x faster than my own design.

Short Clip of it:
https://www.youtube.com/watch?v=RP5WTFzeF3E
https://www.youtube.com/shorts/Fqduyz7H2Mk

Material used

Similar parts should work as well.

1x 3660 2200KV brushless motor
1x 60A ESC
1x 3S 2200mAh LiPo (I also use a 2S 2200mAh a lot since 3S is harder to handle.)
1x receiver
1x SG90 servo (22.7 x 12.2 x 27 mm)
1x 3mm x 100mm steel axle
2x 3x4x10mm stainless steel bearings
2x 3mm x 4mm grub screws
1x MultiBond glue
8x M3 screws (4 for the motor mount, 4 for the jet nozzle)
2x M2.5 screws (servo)

Print settings

Printed on a Snapmaker Artisan.
If your printer can't fit the full hull, print the top section with 0.9 mm larger X/Y dimensions. Overlap the two hull sections by about 20 mm and glue them together.

PETG for everything except the impeller, which was printed in PLA+. I wasn't able to get smooth overhangs with PETG.

No supports for anything.

Vase mode (0.45mm line width)

AxelSleave
Battery_Box
Esc_Box
WaterCoolingConnectors

Vase mode (0.9mm line width)

Hull
HullTop (0mm tolerance, so used -0.4mm Horizontal Expansion)

Optional

These are only there as extra security in case water gets into the hull.

Battery_Box
Esc_Battery_Holder
Esc_Box

If you don't want water cooling, print WaterCoolingConnectors as Solid with 25% height and glue them in as plugs.

Instructions

Eh, you'll figure it out. :D

Just file two flat spots on the axle for the grub screws to grab onto for the impeller.

Payment

Payment is taken in ideas for improvements, or even better, upload a remix with your improvements.