Printrbot Plus Redesign - The Hexbot - For 1311 and 1404

Z/X rebuild works with the 1404 and the 1311 with the Z/X upgrade. There are five prints for that bit.

The body and Y axis is for the 1311 (AKA PB+ v2.1) but you can probably remix it to work.

I didn't make holes for the Printrboard because my design is going to have a unified board/lcd housing outside of the body, but you can easily use another board holder and put it underneath or just plain drill holes for it.

Print the body halves at at least 70% fill and if you're using PLA, use serious glue to hold the two halves together. I used 5 minute epoxy and sort of slathered it on. Same for the two halves of the bed support.

The Y and X axis end stops need to have holes drilled.

The only WIP part at this point is the LCD/Printrboard box, which you may not even want.