FPV camera tilt control

I had a need for a simple and robust tilt solution. So i designed this to do the job.
The base plate is designed to hinge the camera actuator, and to house a futaba S3114 servo.

The arm between the servo horn and camera actuator has a length of 15 mm. I fitted it to the hole with the cut-out area in the pillar on the base plate. This gives me from horizontal to -45 degrees to control.

I redesigned the camera actuator plate because the first design wan't strong enough and able to fit small tie-wraps. This design should be able to withstand all forces.

My idea was to create a flexible platform which fits multiple cameras. The actuator plae consists of small rectangles which should fit small tie-wraps. I'm going to use it to film on a airplane and quadcopter.

The transmitter module that is visible in the picture, and where I designed the baseplate for is a Skyzone 200MW, RC805. I think it is very much like a Boscam TS 351.