micro SD reader mount

After making one of these: http://www.thingiverse.com/thing:816376, I found that I was getting some interference that affected the SD card reader (http://forums.reprap.org/read.php?13,499572,528173#msg-528173). Connecting the SD reader with a shielded cable made the problem vanish. Rather than fitting the SD reader back into the case of the Tiny OLED controller, I thought I'd devise a separate mount that could be conveniently attached to the inside of my briefcase 3D printer case: https://www.youtube.com/watch?v=CZ2MgbKJJE8

This mount is for this variety of micro SD card reader:
http://www.ebay.com/itm/221485468743?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT

The card reader should just push onto the pins. If it is too tight - ream the pin holes out a bit. If it is too loose, use a spot of superglue. The mount is secured with double sided foam tape.