H2O Gassing System Bubbler V2.4

This is an attempt to make an all in one HHO system
Im thinking that if enough amps ran through this system it should make enough HHO to extend your car or truck's gas mileage.

The model is printed upside down ̶a̶n̶d̶ ̶t̶h̶e̶ ̶b̶e̶a̶m̶s̶ ̶b̶e̶t̶w̶e̶e̶n̶ ̶t̶h̶e̶ ̶t̶u̶b̶e̶s̶ ̶o̶n̶ ̶t̶h̶e̶ ̶s̶i̶d̶e̶ ̶a̶r̶e̶ ̶j̶u̶s̶t̶ ̶s̶u̶p̶p̶o̶r̶t̶s̶ ̶I̶ ̶b̶u̶i̶l̶t̶ ̶i̶n̶ ̶t̶o̶ ̶t̶h̶e̶ ̶o̶b̶j̶e̶c̶t̶ ̶b̶e̶c̶a̶u̶s̶e̶ ̶i̶t̶s̶ ̶h̶o̶l̶l̶o̶w̶ ̶a̶n̶d̶ ̶t̶h̶e̶ ̶s̶l̶i̶c̶e̶r̶ ̶w̶o̶u̶l̶d̶ ̶p̶l̶a̶c̶e̶ ̶s̶u̶p̶p̶o̶r̶t̶s̶ ̶i̶n̶s̶i̶d̶e̶ ̶t̶h̶e̶ ̶b̶u̶b̶b̶l̶e̶r̶ ̶t̶a̶n̶k̶ ̶a̶n̶d̶ ̶t̶h̶a̶t̶s̶ ̶n̶o̶t̶ ̶w̶a̶n̶t̶e̶d̶. I removed the outside tubes after rethinking the design and figured it was better to have just a hole to run a tap through and screw in the proper fittings. I printed this out to see how it would come out and it came out awesomely in PLA on my XYZ Da Vinci 1.0 extruder temp of 225C and bed temp of 45C and I found at one of my local dollar stores a glue for the bed if u use it its called MODPODGE its a liquid glue that I apply with a foam brush and it covers the bed great and creates a type of lamination on the bed that the PLA sticks to wonderfully try it out its only a dollar and I use a razor blade paint scraper to get paint off glass to remove the glue and it comes off pretty EZ and comes out of the foam brush with hot water from the tap