Armattan Morphite 10 degree motors mounts

10 degree 1306 motor mounts for the Armattan Morphite

Use 2 for each motor mount, its a little bit of a puzzle but you will figure it out.

You will need to enlarge the screw holes a tad depending on how accurate your printer can produce holes. I used a pin vise and reamer.

You will need to enlarge the holes on your morphite frame to allow the bolts to be at a 10 degree angle. I used a needle file.

These came out at 9.3mm on my printer. I used m2x12mm socket head bolts and washers. Be careful not to damage your motors by using bolts that extend into the motor too much.