K40 CO2 Laser Lid/Cover handle (with switch notch)

I had a couple of LED strips from Costco that were no longer needed and I used them to light up the interior of the laser engraver.

I installed a switch as pictured on top of of the LED strip but also needed a mechanism to press it for my DSP AWC608 to know it is safe to operate the laser and that the cover is closed.

I created this handle to make the case look better and also provide
the required notch to press the switch.

You may have to adjust the smaller piece to fit your setup, but this is a
quick print and you can go through 2-3 iterations and it should not be
that big of a deal to get the perfect fit.