Summary

Based on a model of the stock base the RunCam comes with, tilted at 30 degrees for high-speed FPV.

Instructions

Print with the small face, the front, down. I tested if support was needed, but Slic3r didn't add any. Printed with minimal sagging only at the very top. Might want to check your minimum layer print duration to make sure that is minimized.

v1.2 breaks the tabs into a separate file that should be printed flat to improve flexibility. It snaps into the main piece after printing. May need some trimming of both pieces to get it to fit. When happy with the fit, a few drops of super glue should hold it in.

Be sure to let glue dry thoroughly before inserting your camera!

RunCam 30 degree tilt FPV mount